GT-80 prop question
#26
Thread Starter
Join Date: Sep 2003
Location: HENDERSON, TX
Posts: 819
Likes: 0
Received 0 Likes
on
0 Posts
RE: GT-80 prop question
Well I put the NX 24x10 on and I got 6800 RPM. This seem just about right. It actually runs better than I expected. The cool this is, it was spitting a noticable amount of raw fuel out of the muffler, so it seem it may still be a bit rich. With so toying, I dont think 7000 RPM is completely out of the question with this prop. Ill go in on the High end needle 1/16 this weekend and see what happens. If I can get 7000 out of it, I may make the move to a 25x10.
#27
Senior Member
My Feedback: (8)
RE: GT-80 prop question
Not to change the subject, but can anyone provide me with the motor mount bolt hole dimensions for the Zenoah GT-80 twin. I am planning on mounting it on a 12 foot Telemaster but i'm not sure that the fuse is wide enough.
Thanks in advance for any help!
Randy
Thanks in advance for any help!
Randy