x9503 programming for Radian pro
06-03-2011, 04:48 PM
#1
Member
Thread Starter
Join Date: Apr 2007
Location: Knoxville,
TN
Posts: 73
Likes: 0
Received 0 Likes
on
0 Posts
x9503 programming for Radian pro
I have a new x9503 transmitter and I want to program it for the Radian Pro. The manual and Parkzone site doesnt tell how to setup the 9503 for the Radian Pro. Can some one direct me how to do this. The DX7 directions do not work.
Thanks,
Ind
Thanks,
Ind
02-22-2014, 09:51 AM
#3
Join Date: Aug 2007
Location: Littleton,
CO
Posts: 189
Likes: 0
Received 0 Likes
on
0 Posts
Here is my X9503 Radian Pro setup, if I can attach an image. Some settings like sub trim will depend on the specific model.
Last edited by FrankFuss; 02-22-2014 at 09:54 AM.
02-22-2014, 10:48 AM
#4
My Feedback: (74)
Join Date: Jun 2004
Location: Swanzey,
NH
Posts: 7
Likes: 0
Received 0 Likes
on
0 Posts
FrankFuss ... TNX for the post !! Was able to print and will attempt to check out ... The Rad. Pro is hanging in the basement rafters as we speak ! Lotsa snow and ice here in Nh .
Prolly not much different where you are !!
Buck
Prolly not much different where you are !!
Buck
02-22-2014, 07:14 PM
#5
Join Date: Aug 2007
Location: Littleton,
CO
Posts: 189
Likes: 0
Received 0 Likes
on
0 Posts
Hi Buck,
I would like to point out I used a typical sailplane setup with 5 fight modes, Launch, Land, Cruise, Speed and Thermal. The Cruise, Speed and Thermal modes determine the wing camber settings of the Flaps and Flaperons. The camber can also be changed by the right slider. In Landing mode, the left stick is used to control the Flaps/Crow. The motor control is on the left slider, implemented by the AUX2 to MOTO mixes. This strange MOTO setup is because MOTO must be assigned to some unused control, so we use the BTFL SW (i.e. Butterfly/Gear switch), which is unassigned. A mix is required for both positions of the BTFL SW.
Frank
P.S. The Aileron to Rudder mix should be 35% in all flight modes, instead of being 30% in Cruise mode.
I would like to point out I used a typical sailplane setup with 5 fight modes, Launch, Land, Cruise, Speed and Thermal. The Cruise, Speed and Thermal modes determine the wing camber settings of the Flaps and Flaperons. The camber can also be changed by the right slider. In Landing mode, the left stick is used to control the Flaps/Crow. The motor control is on the left slider, implemented by the AUX2 to MOTO mixes. This strange MOTO setup is because MOTO must be assigned to some unused control, so we use the BTFL SW (i.e. Butterfly/Gear switch), which is unassigned. A mix is required for both positions of the BTFL SW.
Frank
P.S. The Aileron to Rudder mix should be 35% in all flight modes, instead of being 30% in Cruise mode.
Last edited by FrankFuss; 02-22-2014 at 08:01 PM.
