FMA CellPro 4S A123 & Lithium charger
#1
Senior Member
Thread Starter
Join Date: Nov 2005
Location: Henderson, NV
Posts: 2,778
Likes: 0
Received 0 Likes
on
0 Posts
FMA CellPro 4S A123 & Lithium charger
I just wanted to post this for anyone that purchases a FMA CellPro charger for A123 batteries. They come set to charge Lipo's by default. This is obviously not good for for A123's since their peak voltage per cell is 3.7 volts, opposed to 4.2 volts of lipos.
To change the mode, simply HOLD down the MODE button on the top right side of the charger. It will sequence through the different modes. Hold it down until it says "A123."
This note is covered in the instructions, but since most of us do not read them...
To change the mode, simply HOLD down the MODE button on the top right side of the charger. It will sequence through the different modes. Hold it down until it says "A123."
This note is covered in the instructions, but since most of us do not read them...