Help! Gyro problem
#1
Junior Member
Thread Starter
Join Date: May 2002
Location:
Posts: 20
Likes: 0
Received 0 Likes
on
0 Posts
Help! Gyro problem
Hi,
I need to know if a Hitec HS-81 is considered a high speed servo compared to a Robbe FS 50 NANO because I replaced my robbe with the hitec and now con't get the tail to stop wagging no matter how low I set the gain.
I am using the telebee GR703 HH gyro and it is for slow speed servos only so I'm taking a shot in the dark aiming the problem at the new hitec HS-81.
This setup is on a LMH Corona.
I need to know if a Hitec HS-81 is considered a high speed servo compared to a Robbe FS 50 NANO because I replaced my robbe with the hitec and now con't get the tail to stop wagging no matter how low I set the gain.
I am using the telebee GR703 HH gyro and it is for slow speed servos only so I'm taking a shot in the dark aiming the problem at the new hitec HS-81.
This setup is on a LMH Corona.
#2
Junior Member
Join Date: Apr 2003
Location: Parañaque, PHILIPPINES
Posts: 12
Likes: 0
Received 0 Likes
on
0 Posts
Help! Gyro problem
Hi! I don't have corona but I have a very little expirience in GYRO. have you try rotating the gyro 180 or 90 degrees. I have this kind of problem lately in GWS Gyro but i think it's almost thesame.
Hope this will help.
Hope this will help.