MVVS 58 Can/Header
#1
Thread Starter
My Feedback: (42)
Join Date: Jun 2002
Location: Garland,
TX
Posts: 527
Likes: 0
Received 0 Likes
on
0 Posts
MVVS 58 Can/Header
What is optimal header length on MVVS 58 equipped with MTW TD-75K canister?
Is 250mm from exhaust flange to canister inlet too short?
Assuming I am limited to 250mm long double-bend header, what is my best canister option for 3D flying?
Thanks,
Is 250mm from exhaust flange to canister inlet too short?
Assuming I am limited to 250mm long double-bend header, what is my best canister option for 3D flying?
Thanks,
#2
Senior Member
Join Date: Jan 2002
Location: Arcen, , NETHERLANDS
Posts: 6,571
Likes: 0
Received 2 Likes
on
2 Posts
RE: MVVS 58 Can/Header
Marty,
I made a full report on header length using the MTW TD75 in my personal forum at www.prme.nl/forum , see http://www.prme.nl/forum/viewtopic.php?t=54
I made a full report on header length using the MTW TD75 in my personal forum at www.prme.nl/forum , see http://www.prme.nl/forum/viewtopic.php?t=54
#3
Junior Member
My Feedback: (1)
Join Date: Nov 2003
Location: Foster City, CA
Posts: 10
Likes: 0
Received 0 Likes
on
0 Posts
RE: MVVS 58 Can/Header
I have a MVVS 26cc with a Macs rear exhaust header(center line) and a tune pipe. I fly this plane 3D and want a lighter set up. Is anyone using a moose can or larger for this motor and do we have any specs on making one????
Thanks
Thanks