Jetcat P120 constant "Pump Running" lit
02-22-2022, 07:25 PM
Thread Starter
Join Date: Dec 2001
Location: Steens,
MS
Posts: 447
Likes: 0
Received 0 Likes
on
0 Posts
Jetcat P120 constant "Pump Running" lit
I have a P120 that has the kero start conversion. First time hooking everything up to check out the system and the "Pump running" lamp is lit on the GSU and the I/O board. According to the manual, this means the glow plug is defective. However, I have the system in Kero start mode with the Kero plug installed. Changed out all cables with a new set. Same indication. Please help. Thanks.
02-22-2022, 09:56 PM
Join Date: Jun 2002
Location: Watford, UNITED KINGDOM
Posts: 13,132
Only a flashing red light means a failure. Solid red light means pump running…
02-23-2022, 05:41 PM
Thread Starter
Join Date: Dec 2001
Location: Steens,
MS
Posts: 447
Likes: 0
Received 0 Likes
on
0 Posts
Okay, the flashing red light means defective glow plug (in the manual). Does this apply to a kero-start plug?
02-24-2022, 11:46 AM
Join Date: Jun 2002
Location: Watford, UNITED KINGDOM
Posts: 13,132
02-24-2022, 11:48 AM
Join Date: Jun 2002
Location: Watford, UNITED KINGDOM
Posts: 13,132
Does the pump run if you go through to the test menu?
Any noise from the pump when the red light is on?
02-24-2022, 07:23 PM
Thread Starter
Join Date: Dec 2001
Location: Steens,
MS
Posts: 447
Likes: 0
Received 0 Likes
on
0 Posts
Pump does not run. This happens when I first turn it on. I have a P80 with a kero plug. I will swap them out and see if that is the problem.
02-24-2022, 10:02 PM
Join Date: Jun 2002
Location: Watford, UNITED KINGDOM
Posts: 13,132
I think there is a fault on one of the ECU boards.
06-18-2022, 05:58 AM
Join Date: May 2002
Location: Swoyersville,
PA
Posts: 627
Likes: 0
What version ECU ae you running?
Larry
Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off