high speed needle problem
05-12-2007, 11:33 AM
#1
Senior Member
Thread Starter
Join Date: Jan 2007
Location: Washington,
NJ
Posts: 1,580
Likes: 0
Received 0 Likes
on
0 Posts
high speed needle problem
well when i was resetting my car back to factory settings on the high speed needle i turned it in a little far and i started to unscrew the whole high speed needle( like that thing the connects to the fuel was coming out, and the 2 spacers) now when i go to put it back in, it only goes till the first spacer touches the carb and it just spins....?!?
help please
thanks
help please
thanks
05-12-2007, 11:31 PM
#3
Senior Member
Join Date: Feb 2007
Location: thousand oaks,
CA
Posts: 1,669
Likes: 0
Received 0 Likes
on
0 Posts
RE: high speed needle problem
ORIGINAL: sunco1
well when i was resetting my car back to factory settings on the high speed needle i turned it in a little far and i started to unscrew the whole high speed needle( like that thing the connects to the fuel was coming out, and the 2 spacers) now when i go to put it back in, it only goes till the first spacer touches the carb and it just spins....?!?
help please
thanks
well when i was resetting my car back to factory settings on the high speed needle i turned it in a little far and i started to unscrew the whole high speed needle( like that thing the connects to the fuel was coming out, and the 2 spacers) now when i go to put it back in, it only goes till the first spacer touches the carb and it just spins....?!?
help please
thanks
05-12-2007, 11:54 PM
#4
Senior Member
My Feedback: (2)
Join Date: Aug 2004
Location: Butler,
PA
Posts: 2,056
Likes: 0
Received 0 Likes
on
0 Posts
RE: high speed needle problem
Sounds like you stripped the carb body. Remove the whole highspeed needle fitting from the carb and inspect the threads. If the thread are shot you can get a new carb body relatively cheap.
