Different center on JR8411
#1
Member
Thread Starter
Join Date: Jul 2002
Location: ballerup, DENMARK
Posts: 66
Likes: 0
Received 0 Likes
on
0 Posts
Different center on JR8411
Hi there
When I put on the servoarms on two 8411, I canīt set them in same position/angle, they are going to sit two on each aileron and two each side of elevator so they have to sit two on same channel.
Is that normal that center is not similar on different 8411?
How do I work this out?
And offcorse: I can NOT just mowe a toth one toth is to much.
When I put on the servoarms on two 8411, I canīt set them in same position/angle, they are going to sit two on each aileron and two each side of elevator so they have to sit two on same channel.
Is that normal that center is not similar on different 8411?
How do I work this out?
And offcorse: I can NOT just mowe a toth one toth is to much.