speed sensor
08-01-2002, 10:14 PM
#1
Thread Starter
Join Date: Jun 2002
Location: Granby, QC, CANADA
Posts: 458
Likes: 0
Received 0 Likes
on
0 Posts
speed sensor
Does anyone know how to set up the speed sensor for only max speed setting. I have one and I'm going to set it up, but the only thing I want is the max speed. Do I have to calibrate the sensor. Kelly
08-03-2002, 02:53 PM
#2
speed sensor
Hi Kelly,
You just install the sensor per the instructions and plug it in.
MAX LIMITAIRSPD (in the limits menu) is always active, just change that value to whatever you want and you are in business
If you are using 2 channel mode, then do the following,
In the limits menu, set
SPDCTRL SW0 ACT to DISABLED/NONE
and then set
SPDCTRL SW0 ACT to DISABLED/NONE
If you are using one channel mode you don't have to do this.
As for calibration, you can do it if you want it is not mandatory.
Sorry for the delay in answering.
You just install the sensor per the instructions and plug it in.
MAX LIMITAIRSPD (in the limits menu) is always active, just change that value to whatever you want and you are in business
If you are using 2 channel mode, then do the following,
In the limits menu, set
SPDCTRL SW0 ACT to DISABLED/NONE
and then set
SPDCTRL SW0 ACT to DISABLED/NONE
If you are using one channel mode you don't have to do this.
As for calibration, you can do it if you want it is not mandatory.
Sorry for the delay in answering.
