counter rotating pullstart
#1
Senior Member
Thread Starter
Join Date: Mar 2007
Location: england uk, UNITED KINGDOM
Posts: 932
Likes: 0
Received 0 Likes
on
0 Posts
counter rotating pullstart
[:@]was running the cat untill crunch @ about 15000rpm it was flying across the lake with no strange noise broke 3 mount points & 1 x bolt where the mount didnt break.. All cogs are buggered etc etc ...not a happy chap!! What do i do now?Am going to try and get a replacement ...Wayne
#2
Senior Member
Thread Starter
Join Date: Mar 2007
Location: england uk, UNITED KINGDOM
Posts: 932
Likes: 0
Received 0 Likes
on
0 Posts
RE: counter rotating pullstart
The customer service is great bonzisports have done me proud yet again.. Ive a new one on its way today and the old one will be throughly inspected .. should be here within a couple of days[8D] & il be back on the water with it fingers crossed the engines ok it turns over fine by hand but time will tell..
#3
Senior Member
Join Date: Sep 2007
Location: oviedo, FL
Posts: 162
Likes: 0
Received 0 Likes
on
0 Posts
RE: counter rotating pullstart
A little off subject but about those tiny tachs. I have only seen ones that go up to 9999 rpms is there different models of them or are they all the same? Thnaks
#5
Member
Join Date: May 2007
Location: Lockport,
NY
Posts: 99
Likes: 0
Received 0 Likes
on
0 Posts
RE: counter rotating pullstart
You have the standard Tiny Tach (9,999 max) Take a look here http://www.tinytach.com/tinytach/commercial.php (19,990 max).
John
John
#6
Senior Member
Thread Starter
Join Date: Mar 2007
Location: england uk, UNITED KINGDOM
Posts: 932
Likes: 0
Received 0 Likes
on
0 Posts
RE: counter rotating pullstart
[link=http://bonzisports.com/radio.html]click me [/link]
To download the instructions for the tinytach
[link=http://bonzisports.com/images/diagrams/tiny_tach_instructions.pdf]tinytach instructions [/link]
To download the instructions for the tinytach
[link=http://bonzisports.com/images/diagrams/tiny_tach_instructions.pdf]tinytach instructions [/link]
#7
Join Date: Sep 2006
Location: Weed, CA
Posts: 101
Likes: 0
Received 0 Likes
on
0 Posts
RE: counter rotating pullstart
The commercial version is what we reccomend on our Hi Rev motors. You set the tach to the second setting and it will read half the RPM. You just have to double it when you read it. We need these because of the HR motors we reccomend 20,000 to 21,000 at the end of the straight before you enter the next corner.
Todd
Todd