Davette ss new toy
#51
Senior Member
Thread Starter
Join Date: Apr 2007
Location: Wells,
VT
Posts: 475
Likes: 0
Received 0 Likes
on
0 Posts
RE: Davette ss new toy
Jsearcy, I don't know where to get one it was on the boat when I got it. Maybe Billium knows as he was a previous owner.
Had her out today, and after a few mods I think I got just about all this hull will handle. I cut the skeg down from 2 1/2" to about 1 1/4" and did what I'm guessing is a texas cut to the prop by removing some of the bar at an angle out to the tip of the blade then I cupped the tips slightly. She ran around 50 I would say and was hanging out right on the edge. I'll try to get some video tomorrow as I forgot my camera today.
Had her out today, and after a few mods I think I got just about all this hull will handle. I cut the skeg down from 2 1/2" to about 1 1/4" and did what I'm guessing is a texas cut to the prop by removing some of the bar at an angle out to the tip of the blade then I cupped the tips slightly. She ran around 50 I would say and was hanging out right on the edge. I'll try to get some video tomorrow as I forgot my camera today.
#52
Senior Member
Thread Starter
Join Date: Apr 2007
Location: Wells,
VT
Posts: 475
Likes: 0
Received 0 Likes
on
0 Posts
RE: Davette ss new toy
Ok lets see if this works posting a video[link]http://rcuvideos.com/item/6VX37CJD2BPKQCWN[/link]
[link]http://rcuvideos.com/item/R0X9XSX91Y7DWW4P[/link]
[link]http://rcuvideos.com/item/R0X9XSX91Y7DWW4P[/link]
#56
Senior Member
Thread Starter
Join Date: Apr 2007
Location: Wells,
VT
Posts: 475
Likes: 0
Received 0 Likes
on
0 Posts
RE: Davette ss new toy
Yeh that's the first one. It's working pretty good but I'm sure there is room for improvement. It was pretty windy today but at least that kept the black flies down.