new mgt 3.0 project
#1
Senior Member
Thread Starter
Join Date: Feb 2009
Location: HUNTSVILLE,
AL
Posts: 554
Likes: 0
Received 0 Likes
on
0 Posts
new mgt 3.0 project
i have alredy put a .21 in a mini mgt 3.0 now am at it agin just got a brand new all stock mgt 3.0 am going put a vx .18 in it since this engine have all kinds of power and never over heat no matter have lean i run it unlike the stock engine
#5
Senior Member
Thread Starter
Join Date: Feb 2009
Location: HUNTSVILLE,
AL
Posts: 554
Likes: 0
Received 0 Likes
on
0 Posts
RE: new mgt 3.0 project
here pics of the stock engine which is the ae .18 and the one with the blue head is what am putting in vx.18 i already have the stock two speed and the vx fly wheel with the 2 shoe set up
#7
Senior Member
Thread Starter
Join Date: Feb 2009
Location: HUNTSVILLE,
AL
Posts: 554
Likes: 0
Received 0 Likes
on
0 Posts
RE: new mgt 3.0 project
new engine fly wheel is bigger so its hitting the frame ,and i will have to do sum cutting for it to fit . i have the area trace out in red and wrote remove inside so i know home to remove
#8
Senior Member
Thread Starter
Join Date: Feb 2009
Location: HUNTSVILLE,
AL
Posts: 554
Likes: 0
Received 0 Likes
on
0 Posts
RE: new mgt 3.0 project
only thing i had to open up the area for the fly wheel is a 1/4'' DRILL bit i drill a few holes side by side until i got ut almost to where i need it i got a lil bit more to go but its almost there check it out
#11
Senior Member
Thread Starter
Join Date: Feb 2009
Location: HUNTSVILLE,
AL
Posts: 554
Likes: 0
Received 0 Likes
on
0 Posts
RE: new mgt 3.0 project
i already had the engine took it out of my off road buggy it already broken in and its a year old today still have the stock glow pulg and have the same amount of power it had when it was new i did take it apart and give it a good cleaning , i put a vx.16 in the buggy
#14
Senior Member
Thread Starter
Join Date: Feb 2009
Location: HUNTSVILLE,
AL
Posts: 554
Likes: 0
Received 0 Likes
on
0 Posts
RE: new mgt 3.0 project
now i have the engine in and the pipe on as well as the head , just got to put the fuel tank back on run the fuel lines and put the rear main dog bone back in mean while am going test start the engine to check the meash