Associated XP3-SS 2.4GHz
12-26-2011, 01:49 PM
#1
Associated XP3-SS 2.4GHz
Anybody have any troubles with this transmitter losing it's bind? Ran my daughter's new truck one time and went to take it out again and the transmitter lost it's bind with the RX. Tried to rebind it with no success. It says to press the bind button and hold, then power up the trans. Light should start blinking green. Problem is, it just stays lit up solid red no matter what.
I took my son's transmitter and easily bound that to the new truck, so it is definitely a problem with the transmitter. Any ideas on what is going on?
I took my son's transmitter and easily bound that to the new truck, so it is definitely a problem with the transmitter. Any ideas on what is going on?
01-11-2012, 07:01 PM
#2
Member
My Feedback: (2)
Join Date: Dec 2011
Location: PittsburgKS
Posts: 91
Likes: 0
Received 0 Likes
on
0 Posts
RE: Associated XP3-SS 2.4GHz
Please pardon the thread-jacking, as it was more appropriate than starting another thread for the same radio.
I'm looking for a tx battery pack to use with this transmitter that has the same connector thats in the radio. Its not the rectangular balance connector, but a square one with a red and black wire. Any suggestions? I don't wanna resort to individual rechargeable AA batteries without trying to find a pack first. Thanks.
mrbigg, another apology for the thread jacking.
I'm looking for a tx battery pack to use with this transmitter that has the same connector thats in the radio. Its not the rectangular balance connector, but a square one with a red and black wire. Any suggestions? I don't wanna resort to individual rechargeable AA batteries without trying to find a pack first. Thanks.
mrbigg, another apology for the thread jacking.
