Lights at the top of the vertical fin. How to wire?
#1
Senior Member
Thread Starter
Join Date: Sep 2006
Location: Grande Prairie,
AB, CANADA
Posts: 630
Likes: 0
Received 0 Likes
on
0 Posts
Lights at the top of the vertical fin. How to wire?
I am putting in a lighting system for my 1/8th scale F-16. Does anyone have some advice on how to drill from the top of the fin down to the bottom to allow the hookup wires? I'm concerned that I will weaken the structure if I start drilling.
#2
RE: Lights at the top of the vertical fin. How to wire?
If you use a jewelers file strike a small flat area as large as the light you wish to mount, you may end up with a hole by doing this. Make sure you are using sharp drills. Take a small drill, say half the size of the hole you need and start it by twirling it between your fingers, then use a Dremel tool to finish the small hole. Next select the size drill to fit the need and very slowly drill the hole. This way you have not put a lt of pressure on the seam, if there is one!
#3
My Feedback: (2)
RE: Lights at the top of the vertical fin. How to wire?
The trick is getting the hole started in the right place.
As mentioned, start by making a flat, then start the hole with a smaller bit in a pin vise.
Then depending on the fin construction (foam filled, hollow built up) follow that up with a drill bit long enough to reach thru and just big enough for the wires. Drill very slowly so that the drill does not catch and break things.
Then open up the hole on top to fit the light. Depending on construction it may be better to drill or better to use a Dremel.
As mentioned, start by making a flat, then start the hole with a smaller bit in a pin vise.
Then depending on the fin construction (foam filled, hollow built up) follow that up with a drill bit long enough to reach thru and just big enough for the wires. Drill very slowly so that the drill does not catch and break things.
Then open up the hole on top to fit the light. Depending on construction it may be better to drill or better to use a Dremel.
#4
RE: Lights at the top of the vertical fin. How to wire?
On composite do not use a drill larger than 1/8" otherwise it will snag on the seam joint glue and cause damage.
Open up with Dremel. There are usually lightening holes in the fin ribs, use some cotton with a dremel collet for weight and dangle it through the structure, you should find a route through.
Open up with Dremel. There are usually lightening holes in the fin ribs, use some cotton with a dremel collet for weight and dangle it through the structure, you should find a route through.