Motonica P81 1/8 cnc conversion
#1
Junior Member
Thread Starter
Join Date: Jul 2005
Location: Ancona, ITALY
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
Motonica P81 1/8 cnc conversion
Hi guys,
I have a Motonica P81 RS that I converted to brushless.
It's been an hard work. This is my set up:
Motor Tekin 2650 kv
Batteries: 4s 6000mah or 6s 4200mah shorty
Frame: Black glass fiber 5mm (I previously built a cnc machine) and purple anodized belt tensioner
I hope you like it !!! I all made myself so please be gentle !!!
Regards, Federico
I have a Motonica P81 RS that I converted to brushless.
It's been an hard work. This is my set up:
Motor Tekin 2650 kv
Batteries: 4s 6000mah or 6s 4200mah shorty
Frame: Black glass fiber 5mm (I previously built a cnc machine) and purple anodized belt tensioner
I hope you like it !!! I all made myself so please be gentle !!!
Regards, Federico
#3
Senior Member
Join Date: Mar 2005
Location: Kingston UK, but living in Athens, GREECE
Posts: 18,082
Likes: 0
Received 3 Likes
on
3 Posts
RE: Motonica P81 1/8 cnc conversion
Very. I've seen one of these go and I was totally blown away. Apart from the sheer power to weight ratio which is just insane, the corner speed is also mind-blowing. These cars are like F1 crs in that respect, there's actually a speed UNDER which you cannot enter a corner, as you require forward motion to generate downforce.
#4
Junior Member
Thread Starter
Join Date: Jul 2005
Location: Ancona, ITALY
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
RE: Motonica P81 1/8 cnc conversion
I think it will be in the high 70s.
I hope handling to be better than original having batteries in the middle.
I still have to try it. I hope next week, still some work to do.
I hope handling to be better than original having batteries in the middle.
I still have to try it. I hope next week, still some work to do.