Schumacter/Thundertiger/BFG engine Screw?
09-19-2003, 04:09 PM
#1
Senior Member
Thread Starter
My Feedback: (1)
Join Date: Jul 2003
Location: State College,
PA
Posts: 681
Likes: 0
Received 0 Likes
on
0 Posts
Schumacter/Thundertiger/BFG engine Screw?
alright.. I have a Pro 21 R engine from thunder tiger.. and I can't find the screw that goes into the engine shaft that screws on the clutch bell.
This engine is also in the Schumacter Fusion. so if someone knows where to get schumacter parts
This engine is also going to be in the new Team Associated Monster Truck BFG.
or if someone knows where to get this screw... it's smaller than a 3 mm.. but a 2.5 mm is too small for it.. so it's a standard size.....
help!!!!!!!!!!
Jack
This engine is also in the Schumacter Fusion. so if someone knows where to get schumacter parts
This engine is also going to be in the new Team Associated Monster Truck BFG.
or if someone knows where to get this screw... it's smaller than a 3 mm.. but a 2.5 mm is too small for it.. so it's a standard size.....
help!!!!!!!!!!
Jack
09-20-2003, 07:34 PM
#4
Senior Member
Join Date: Feb 2003
Location: sydney, AUSTRALIA
Posts: 664
Likes: 0
Received 0 Likes
on
0 Posts
RE: Schumacter/Thundertiger/BFG engine Screw?
lol i am pretty sure the screw is a 2.5 mm screw. i have 2 of these engines. i will check what size they are and get back to ya!!
09-22-2003, 10:35 AM
#6
Senior Member
Thread Starter
My Feedback: (1)
Join Date: Jul 2003
Location: State College,
PA
Posts: 681
Likes: 0
Received 0 Likes
on
0 Posts
RE: Schumacter/Thundertiger/BFG engine Screw?
it has been found!.. it was 2.5 mm. THanks man!! stupid idiot LHS was too lazy to make sure it fit right..
