mikes68charger

My Feedback: (34)

Ok guys I'm loseing my mind.

This is my 2nd ZDZ so I know there dif to start.

Im putting this ZDZ80 Blue head on my new 50cc 81in GeeBee R3.


Im haveing major interverance issue with the throtel servo

I have 9 othere gassers so I'm going with the norm

I was useing a opto kill swich with its own 6.6 life battery and once I got the motor running it was ok but when I tried to power up the throtel servo would skip/jump all over the place makeing the motor to run odd

I have tried everything. Makeing sure no wires are touching the 4-40 rod that has plastic connectors and plastic servo arms. I tried 2 kill swiches, 2 diff servos. Hitec 422 plastic and hs 645 MG , I tried a regular on off swich with no connections to the reciver power system.

The only thing that works is if I plug the separate 6.6 life right into the ignition with no swich of any kind

i can't fly like this this motor to big not to have a electronic kill swich by TX

any ideals ?

it also has a spark plug cap unlike any I have seen.
Could it be the plug?

im using DX18 with AR7000

thanks mike

BadAzzMaxx

You could have arcing inside the plug cap.

Try wrapping some tin foil tightly around the cap and a little ways down the plug wire and see if it does the same thing,

Milton

mikes68charger

My Feedback: (34)

Well I think it's fixed guys

i added a small green mag ring to the ign wire with 4 raps around the magnet

everything works. Kill swich to reciver and all. Humm

irocbsa

My Feedback: (12)

Hey Mike, good to hear the engine is up and running. When I ran it on my test stand I didn't have a servo hooked up to the throttle or I would have let you know about something like this. Anyway, glad the electrical "choke" fixed it.