EQ6 Turbo and Futaba 617FS plus aileron question
#1
Thread Starter
EQ6 Turbo and Futaba 617FS plus aileron question
Hello Robert,
Is it OK to plug channel 8 into the channel 7 port on this RX? It shares the RX power in and channel 7 function. That give me redundant power (channel 1 and 7) to the RX.
I run 4 aileron servos (2 per side) I am wondering about the wear and tear on the pins of the EQ6 when taking the wings on and off every time I fly. I have been using short servo extensions off the EQ6 so that the wear would occur on them and not the EQ6. Am I worried for nothing? Is there a better way?
Is using a short Y-harness ok so that I can plug all 4 aileron servos into port 1? I am running Hitec 7955's.
Is it OK to plug channel 8 into the channel 7 port on this RX? It shares the RX power in and channel 7 function. That give me redundant power (channel 1 and 7) to the RX.
I run 4 aileron servos (2 per side) I am wondering about the wear and tear on the pins of the EQ6 when taking the wings on and off every time I fly. I have been using short servo extensions off the EQ6 so that the wear would occur on them and not the EQ6. Am I worried for nothing? Is there a better way?
Is using a short Y-harness ok so that I can plug all 4 aileron servos into port 1? I am running Hitec 7955's.