hard points
#1
Senior Member
Thread Starter
My Feedback: (1)
Join Date: Dec 2001
Location: Hammond,
IN
Posts: 3,262
Likes: 0
Received 0 Likes
on
0 Posts
hard points
On the Wild Hare Extra, should the hard points for the ailerons and elevators be drilled at 90 degrees to the center line of the control surface? I read where there is a pilot hole drilled, but I want to make sure of the correct angle.
#2
Senior Member
Join Date: May 2002
Location: Flower Mound (near Dallas),
TX
Posts: 6,189
Likes: 0
Received 2 Likes
on
2 Posts
RE: hard points
ORIGINAL: Diablo-RCU
On the Wild Hare Extra, should the hard points for the ailerons and elevators be drilled at 90 degrees to the center line of the control surface? I read where there is a pilot hole drilled, but I want to make sure of the correct angle.
On the Wild Hare Extra, should the hard points for the ailerons and elevators be drilled at 90 degrees to the center line of the control surface? I read where there is a pilot hole drilled, but I want to make sure of the correct angle.
I use a cordless screwdriver instead of a drill, driving a bit with a hex quick-change base. The screwdriver is easier to control and goes nice and slow. It only takes a little bit to drill it to the right size.
Tom Fawcett