microbeast plus setup for Trex 500XT issue
10-31-2017, 01:57 PM
#1
Junior Member
Thread Starter
Join Date: Dec 2015
Posts: 6
Likes: 0
Received 0 Likes
on
0 Posts
microbeast plus setup for Trex 500XT issue
First electric FBL this size and needing guidance.
Setup went well and now complete. Chose parameter B "transmitter". I chose this given my desire to use start off with beginner throttle/pitch curves as well as reduced collective and cyclic throws.
I was able to accomplish the desired collective curves and endpoints but I have been unable to tame the cyclic. I was looking to get the cyclic in at around 8 degrees but DR and servo travel adjustments do not get either cyclic to move off 13.5 to 14.0 degrees.
DX8 radio/AR7700 single line RX
Measured with 0 pitch /aileron blades parallel to boom/elevator 90 degrees to boom.
What am I missing?
Thanks!
Tom
Setup went well and now complete. Chose parameter B "transmitter". I chose this given my desire to use start off with beginner throttle/pitch curves as well as reduced collective and cyclic throws.
I was able to accomplish the desired collective curves and endpoints but I have been unable to tame the cyclic. I was looking to get the cyclic in at around 8 degrees but DR and servo travel adjustments do not get either cyclic to move off 13.5 to 14.0 degrees.
DX8 radio/AR7700 single line RX
Measured with 0 pitch /aileron blades parallel to boom/elevator 90 degrees to boom.
What am I missing?
Thanks!
Tom
