uniLIGHT Controller, 8-Channel, PRO
#1
Thread Starter
uniLIGHT Controller, 8-Channel, PRO
Need help setting up this light controller. Have read the instructions and watched the u-tube video, but still haven’t been able to get this to do what I want. The instructions are very poor in my opinion. If anybody out there has been able to program it, I would greatly appreciate it, maybe it would be an opportunity to wright up a new and better instructions manual.
Keep safe everybody
Keep safe everybody
The following users liked this post:
SkyKnight (08-25-2020)
#2
My Feedback: (11)
I have programmed a couple of them. Yeah, it’s not that easy, but doable.
I have to program another one shortly here, so I will have my memory refreshed. From what I remember, you have to have a PC, make sure the correct USB port is selected, you have to wait and save before EVERY change,....hmmm, I can’t think of anything else right now.
There is a thread or two on this controller, have you read through them?
I have to program another one shortly here, so I will have my memory refreshed. From what I remember, you have to have a PC, make sure the correct USB port is selected, you have to wait and save before EVERY change,....hmmm, I can’t think of anything else right now.
There is a thread or two on this controller, have you read through them?
#3
Thread Starter
Hi my friend, long time since we were together in California, hopes you are doing well.
Would be great to start this make a good instructions manual. These are the basic steps so far that I have done.
Teach the controller to the radio channel that you are going to use.
Then you need a PC
Plug the USB without a battery to the PC so they connect.
Start the unilight program on your PC.
And here is where the confusion starts.
Let’s say you have 2 strobes and one beacon a 3 different schemes... do you transfer one scheme at a time
when do you connect the battery to the unilight controller? Before or after you transfer?
Is you airplane powered on at this time or not?
Would be great to start this make a good instructions manual. These are the basic steps so far that I have done.
Teach the controller to the radio channel that you are going to use.
Then you need a PC
Plug the USB without a battery to the PC so they connect.
Start the unilight program on your PC.
And here is where the confusion starts.
Let’s say you have 2 strobes and one beacon a 3 different schemes... do you transfer one scheme at a time
when do you connect the battery to the unilight controller? Before or after you transfer?
Is you airplane powered on at this time or not?