Morris profile plans
#2
Senior Member
My Feedback: (2)
Join Date: Apr 2020
Location: Metro Atlanta GA, USA
Posts: 442
Likes: 0
Received 36 Likes
on
32 Posts
Good question. I found a set of Morris Pen Knife plans in an old box. That plane was a hoot - especially when I replaced the .20 2C with a .40 4C. Then it really came alive. That was around 30 years ago.
I will probably keep these plans, in case I ever take a notion to build one again. That is, unless you have Top Cap or some other plans that you might want to trade for the Pen Knife plans.
I will probably keep these plans, in case I ever take a notion to build one again. That is, unless you have Top Cap or some other plans that you might want to trade for the Pen Knife plans.
#3
Thread Starter
My Feedback: (1)
Thanks for the response! I'm not interested in trading but am looking for people interested in building these old planes. I don't have TopCap plans though.
On hand: Not For Sale, 42" wing, .15 to .36 engine
Profile Hots, 34" wing, .21 to .30 engine
Hangar 9 Profile Gee Bee, 48" span, .40 to .50 engine (Designed by Adrian Page. Very aerobatic)
Also have some large R/C plans available if anyone is interested.
On hand: Not For Sale, 42" wing, .15 to .36 engine
Profile Hots, 34" wing, .21 to .30 engine
Hangar 9 Profile Gee Bee, 48" span, .40 to .50 engine (Designed by Adrian Page. Very aerobatic)
Also have some large R/C plans available if anyone is interested.
#4
Junior Member
Join Date: Apr 2024
Location: Murfreesboro, TN
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
Are these plans still available? I've been building planes since this past August, and am eager to find some original plans. I am also in the process of restoring three balsa profiles, one of which should be ready to maiden in the next week or so.
#10
Junior Member
Join Date: Apr 2024
Location: Murfreesboro, TN
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
Tried to upload a picture of my scratch built Smith Super Special but I'm also restricted on uploading 'URL's' until 10 posts. Maybe I can get away with sharing them over PM.