TMMY Scale Composites 35% scale Cessna
#2003
I have not gotten that far but if your back through the thread I am sure others have posted what they have done.
I'd also research what settings the full size uses, given the size of this model that would be a good place to start.
I'd also research what settings the full size uses, given the size of this model that would be a good place to start.
#2004
Thread Starter
My Feedback: (23)
Saul
The following users liked this post:
Super18 (08-11-2024)
#2007
your dash is a lot better than the one I got. Original owner must have told them to just supply an old steam gauge dash.
I will make a new one.
Mine is deferred for the time being, still waiting on the brakes and associated hub machining.
I will make a new one.
Mine is deferred for the time being, still waiting on the brakes and associated hub machining.
The following 2 users liked this post by scottkieper:
planenutzz (08-29-2024),
Super18 (08-30-2024)
#2017
came out nice, well done. Instrument panel does look good. Mine is on hold till I get the brakes sorted, friend is doing machining for me.
I need to get all the G1000 surrounds etc for mine, was going to get somebody to program up some functional ones but think it will be too expensive to do.
One thing to watch is with the seats, they are quite flimsy at the outside of the bend and will crack. I am going to put a layer of either carbon fiber or 6oz cloth to that area.
What size fuel tank did you put in?
cheers
P
I need to get all the G1000 surrounds etc for mine, was going to get somebody to program up some functional ones but think it will be too expensive to do.
One thing to watch is with the seats, they are quite flimsy at the outside of the bend and will crack. I am going to put a layer of either carbon fiber or 6oz cloth to that area.
What size fuel tank did you put in?
cheers
P
#2020
Did that panel come standard with the kit? Looks very good. I am not happy with mine but it was from one of the early releases of this model. I could get iflytaillies to make me one but will be expensive.
I contacted Tommy to see if he can do me a panel like yours.
I contacted Tommy to see if he can do me a panel like yours.
Last edited by planenutzz; 09-28-2024 at 02:20 PM.
#2022
I am supposed to get all the brakes and machiningg completed by Christmas, hope so as I have a few weeks off then and want to get it up on its wheels and work on it.
Have to collect a few other bits yet, new Powerbox Competition SRS, batteries, Powerbox Sparkswitch RS and Powerbox telemetry bits.
#2023
I will have to check how much room would be behind the panel.