TopRCModel FW-190
#1676
Hi all!
Sorry for not getting back to you sooner. I left the hobby after 25 years of hardcore building to persue motorcycle offroading. Almost the same as RC flying - costs craploads of money and after a day of fun theres always something broken.
Anyways, I am still making the TOPRC Fans, Exhaust Stacks, and some other goodies. best send me a personal message and I will send you my phone number for whatsapp.
Rev
Sorry for not getting back to you sooner. I left the hobby after 25 years of hardcore building to persue motorcycle offroading. Almost the same as RC flying - costs craploads of money and after a day of fun theres always something broken.
Anyways, I am still making the TOPRC Fans, Exhaust Stacks, and some other goodies. best send me a personal message and I will send you my phone number for whatsapp.
Rev
#1677
Junior Member
Join Date: May 2024
Posts: 4
Likes: 0
Received 0 Likes
on
0 Posts
Good Afternoon Reverend
Apparently the system will not allow me to send you a personal message. Can you contact me Via my email. [email protected]
Thank You
Apparently the system will not allow me to send you a personal message. Can you contact me Via my email. [email protected]
Thank You
#1678
Stand offs
Hi guyz, can somebody tell me how long stand offs I need? Would safe me a lot of time measuring and/or trial fitting. I have a Saito FG90R3 with a three blade Ramoser prop.
Thanks Marco
Thanks Marco
#1681
stand it on its tail with rudder off and secure to a step ladder, position the engine so it sits on the engine mount drill marks then do a trial fit of the cowl, make sure cowl is seated correctly then measure for prop hub face and centering within the cowl.
The centring is critical if you wish to fit a fan.
Adjust as necessary building it up till you have engine at correct distance from firewall. Note I used a piece of 8mm steel plate to add nose weight so might stand offs are a bit shorter than others.
Have a look back over my posts where I did this.
Measure, measure, measure then repeat!
The centring is critical if you wish to fit a fan.
Adjust as necessary building it up till you have engine at correct distance from firewall. Note I used a piece of 8mm steel plate to add nose weight so might stand offs are a bit shorter than others.
Have a look back over my posts where I did this.
Measure, measure, measure then repeat!
#1683
#1685
There is always something! I have not flown in about 4 months as my landrover is in getting transmission done and there has been back log with parts and getting valve body done.