Bikerboy53

My Feedback: (1)

Hey all,

I know I've mentioned this before in a different thread, and I hope that I'm not beating a "dead horse" here. I bought a kit (well at least I THOUGHT I did) for a "Goldwing 1/3 scale Piper J3 Cub at a local swap meet a while back, it's a beautiful aircraft, but when I started digging into it and attempting to put things together, I noticed some of the parts were either missing or just did NOT match the assembly guide at all and I'm thinking that this was a total joke, so NOW I'm scrambling to find the hardware for the wing struts OR maybe some guidance on how I'm supposed to finish this thing in time for the summer flying season. Does ANYONE know where I can find spare parts for this??, I'm guessing the company went out of business because I cannot raise them at all.

ANY help at all would be greatly appreciated.

Biker


Here's the photos of the hardware that I need

Truckracer

My Feedback: (19)

Unless you are lucky enough to find someone who has the parts or has an old airframe, I'm thinking you will have to build the parts yourself. In non ARF kits like the Balsa USA 1/4 or 1/3 or SIG 1/4 CUB these were typically made by the builder. You could adapt those practices to finish your ARF. Good luck though, maybe someone will come through. GoldWing has been gone for awhile now.

Bikerboy53

My Feedback: (1)

I was afraid you might say that TR, I'm wondering if I could 3D print the latch bolts, the rest I can fab on my own, but it sure would be nice to have some dimensions to work with.

Thanks for the input TR

Biker

Bikerboy53

My Feedback: (1)

The circled parts are the ones I was thinking about 3D printing
Any input would be appreciated

thanks all

Biker

Jeff Foley

My Feedback: (45)

Those are called spade bolts. Ive seen them listed in Mcmaster carr....although I don't know what sizes they have and whether they are metric or not. You may be able to find some there....or do a google search. I will also look in my stash.....seems like I remember seeing them in some older control line kits for holding landing gear wire.

Jeff

Bikerboy53

My Feedback: (1)

Thank you Jeff, much appreciated :-)

Tony Hallo

I just made new jury struts for mu 1/3 scale Champ. I used K&S aluminum streamline tube tube when I built it but it is a little on the weak side so I ordered stainless steel streamline tube from Toni Clark in Germany, $40 for the tube, $40 to ship! I don't need to worry about it bending.

Bikerboy53

My Feedback: (1)

WOW, VERY nice work Tony!...that's pretty much the same thing I'm looking at doing for my 1/3 Cub, thank you for posting this, that's something I can do until I figure out what these parts are, can you or anyone else ID these circled parts?

Thanks so much!

Biker

Tony Hallo

I guessing those parts are the strut end fittings. These would be inserted into the strut and attached with a through bolt. The four fittings shown in the bottom right side photo on the first post are screwed to the wing and the end fitting attaches there with the four pins shown.

Bikerboy53

My Feedback: (1)

Sorry it's been a bit, thank you to all you guys for your help!!