Down and locked DL-550 programming
#1
Thread Starter
Down and locked DL-550 programming
Hi Guys,
I have the DL 550 gear controller and the tail retract I have it connected to is not fully retracting so I need to adjust the end point.
I cannot find any instructions on how to do this and I don’t have the software to do it. I have the cycling switch attached to the unit.
Is anyone able to help with this?
Thanks in advance!
I have the DL 550 gear controller and the tail retract I have it connected to is not fully retracting so I need to adjust the end point.
I cannot find any instructions on how to do this and I don’t have the software to do it. I have the cycling switch attached to the unit.
Is anyone able to help with this?
Thanks in advance!