CARF Joker build thread
The following users liked this post:
Andrewfordham (10-30-2022)
#953
My Feedback: (29)
Hi!
I just bought a replacement Joker, I had lost mine several months ago in a ground roll incident. Mine flew so good I just needed to get a new one, and since I have all the equipment (except the thrust pipe) from the previous one, it made all the sense in the world to just get a replacement. Yet I truly did not like the Carf pipe, when I bought the replacement fuse, the pipe was not available, so I will just go ahead and install a conventional pipe, can any of you guys share the dimension from the rear former of the engine mount to the rear fuselage oulet?
Thanks
I just bought a replacement Joker, I had lost mine several months ago in a ground roll incident. Mine flew so good I just needed to get a new one, and since I have all the equipment (except the thrust pipe) from the previous one, it made all the sense in the world to just get a replacement. Yet I truly did not like the Carf pipe, when I bought the replacement fuse, the pipe was not available, so I will just go ahead and install a conventional pipe, can any of you guys share the dimension from the rear former of the engine mount to the rear fuselage oulet?
Thanks
The following users liked this post:
DenisFerrari (12-03-2023)
#960
My Feedback: (29)
Guys, my replacement Joker has arrived, I’m in the assembly process.
My previous Joker I got secondhad, so I did not assemble it, I’m the process of installing the stab servos, would like to know if anyone has used an alternate method to install the servos that will not warp the upper stab skin, any suggestions?
My previous Joker I got secondhad, so I did not assemble it, I’m the process of installing the stab servos, would like to know if anyone has used an alternate method to install the servos that will not warp the upper stab skin, any suggestions?
The following users liked this post:
DenisFerrari (12-18-2023)
The following users liked this post:
DenisFerrari (12-18-2023)
#964
Junior Member
New Owner?
The intakes were a bugger to get. Schubeler was not good at responding to my requests, although they did eventually reply much later. So, I contacted Gary at Efflux RC, because he sells their stuff in the USA. He was able to get me a set. The are part of the EFD conversion kit Schubeler makes.
They are not a drop in fit. Much cutting and sanding was needed, and I didn't do as good as a job as F-1 did. The fuselage at the intakes needs touch up paint, this is unavoidable. You can see that F-1 added silver paint to LA Jet Guys intakes.
But they do look cool.
They are not a drop in fit. Much cutting and sanding was needed, and I didn't do as good as a job as F-1 did. The fuselage at the intakes needs touch up paint, this is unavoidable. You can see that F-1 added silver paint to LA Jet Guys intakes.
But they do look cool.
I was just searching the web and saw your posts for your Joker build. I’m about to do some work on the turbine mounting “plates”. I think mine has similar misalignment issues as you found on yours. Did you still have your Joker?
Thanks