Cowl Cut-outs
#1
Member
Thread Starter
Join Date: Dec 2003
Location: Winnipeg, MB, CANADA
Posts: 47
Likes: 0
Received 0 Likes
on
0 Posts
Cowl Cut-outs
In most ARF kits they suggest using cardboard for marking muffler, needle valve positions to transfer to your fibreglass cowl as a guide for making your cuts. Try using thin mylar, then you can see exactly where the needle valve etceteras exactly is, no guessing.... I use old/used overhead projection mylar, free and works the best!
Len
Len
#2
Senior Member
Join Date: Feb 2004
Location: Buenos Aires, ARGENTINA
Posts: 245
Likes: 0
Received 0 Likes
on
0 Posts
RE: Cowl Cut-outs
Nice idea and for cut those cowls atach a exacto blade to a soldering iron with some wire, when the blade is heat will cut the plastic like buttler, try it