GWS EDP50 DD rotor question
03-17-2004, 11:43 AM
#1
Thread Starter
Join Date: Dec 2003
Location: Small Town,
VT
Posts: 157
Likes: 0
Received 0 Likes
on
0 Posts
GWS EDP50 DD rotor question
Hi all,
I just picked up one of these little DD tail motors w/ the 3020 props and was wondering how to moutn the props? Do you enlarge the hole, or just jam it on. Tips please. Thanks,
j
I just picked up one of these little DD tail motors w/ the 3020 props and was wondering how to moutn the props? Do you enlarge the hole, or just jam it on. Tips please. Thanks,
j
03-17-2004, 12:06 PM
#2
Senior Member
Join Date: Dec 2003
Location: San Jose, CA
Posts: 167
Likes: 0
Received 0 Likes
on
0 Posts
RE: GWS EDP50 DD rotor question
Hi,
I've mounted DD motor on hummingbird horizontal fin bracket. This way I can slide forward/backward for better balance. This tip is from Xbox at RunRyder forum.
For mounting prop, I just enlarge hole a little. Also a tiny drop of superglue would help too but be careful.
Regards.
I've mounted DD motor on hummingbird horizontal fin bracket. This way I can slide forward/backward for better balance. This tip is from Xbox at RunRyder forum.
For mounting prop, I just enlarge hole a little. Also a tiny drop of superglue would help too but be careful.
Regards.
03-17-2004, 12:55 PM
#3
Senior Member
Join Date: Sep 2003
Location: Sheffield, UNITED KINGDOM
Posts: 163
Likes: 0
Received 0 Likes
on
0 Posts
RE: GWS EDP50 DD rotor question
Just Rammed it on
I held the motor end cap to ensure it didn't pop out.
The blade does pop off with any large tail strike - which is fine by me (better than shattering into little bits!)
Experiment and use what works for you
Steve
I held the motor end cap to ensure it didn't pop out.The blade does pop off with any large tail strike - which is fine by me (better than shattering into little bits!)
Experiment and use what works for you
Steve
