help with tc3
#1
Junior Member
Thread Starter
Join Date: May 2004
Location: Goldsboro,
NC
Posts: 19
Likes: 0
Received 0 Likes
on
0 Posts
help with tc3
im racing my tc3 for the first time tommorrow and when i pull the trigger it just spins the tires and when i try to turn it does a 180.when i try to recover from the 180 i end up doing donuts.i have a epic outlaw stock motor with a 25 pinion and a 74 spur.
#3
Senior Member
Join Date: Aug 2003
Location: Springdale, AR,
Posts: 173
Likes: 0
Received 0 Likes
on
0 Posts
RE: help with tc3
You've lost something in the front differential and/or driveshafts. Rebuild it according to your manual, and you should find out why you only have rear wheel drive.
#5
Junior Member
Thread Starter
Join Date: May 2004
Location: Goldsboro,
NC
Posts: 19
Likes: 0
Received 0 Likes
on
0 Posts
RE: help with tc3
all 4 whells spin with the car elevated and all four spin when its on the ground.for the first second or two all four wheels are spinning but the car isnt moving
#6
Senior Member
Join Date: Jun 2003
Location: cardiff,
Posts: 391
Likes: 0
Received 0 Likes
on
0 Posts
RE: help with tc3
check that you have all pin's in the the wheel hubs that happened to me once all 4 wheels were spinning but there was alot more power going to the bacck of the car i was using a 27t stock abnd spinning out it was real hard work
#7
Senior Member
Join Date: Jun 2003
Location: Carpinteria, CA
Posts: 634
Likes: 0
Received 0 Likes
on
0 Posts
RE: help with tc3
So, when you pull the trigger, all the tires spin but the car doesn't move until they get traction?
If that's the case, try pulling the trigger a little easier.[:@]
Wait a minute: Did you run the setup procedure for your ESC correctly?[:@]
If that's the case, try pulling the trigger a little easier.[:@]
Wait a minute: Did you run the setup procedure for your ESC correctly?[:@]
#8
RE: help with tc3
Ok your throwing me off with the whole
part..
But I think that your linkages may not be setup right.
It should look like this
---------------------ZERO-|$$$THROTTLE$$$|
--|$$$BRAKE$$$|-ZERO------------------------
But I think yours looks like this:
-------------------ZERO-|$$$THROTTLE$$$|
------------|$$$BRAKE$$$|------------------
So here.. your applying brakes even when your doing anything!! Worse.. maybe your applying brakes when your partially applying throttle.. so because of your differential.. the one with weakest braking is turning but only doing a burnout because other wheels are braking??
Possible.. but unlikely theory
ram
all four spin when its on the ground.for the first second or two all four wheels are spinning but the car isnt moving
But I think that your linkages may not be setup right.
It should look like this
---------------------ZERO-|$$$THROTTLE$$$|
--|$$$BRAKE$$$|-ZERO------------------------
But I think yours looks like this:
-------------------ZERO-|$$$THROTTLE$$$|
------------|$$$BRAKE$$$|------------------
So here.. your applying brakes even when your doing anything!! Worse.. maybe your applying brakes when your partially applying throttle.. so because of your differential.. the one with weakest braking is turning but only doing a burnout because other wheels are braking??
Possible.. but unlikely theory
ram