BME 50
#1
Senior Member
Thread Starter
My Feedback: (1)
Join Date: Apr 2002
Location: MadisonLake,
MN
Posts: 205
Likes: 0
Received 0 Likes
on
0 Posts
BME 50
I had this new since Feb, the motor run well once the first time, then shuts off. I have sent it back, very good Customer service. They check the motor, sent the ingntion to C & H all check out.
2nd flight it just stoped again. No spark. check Battery , switch, all the wire nothing.
Inform them of it.
They are telling me maybe they have a bad bunch of sensors. Not to fire it unless it was grounded.
We have not done this the engine was in flight and running all times and just stops.
They say that there are 2500 of thease out there, anyone else having problem?
2nd flight it just stoped again. No spark. check Battery , switch, all the wire nothing.
Inform them of it.
They are telling me maybe they have a bad bunch of sensors. Not to fire it unless it was grounded.
We have not done this the engine was in flight and running all times and just stops.
They say that there are 2500 of thease out there, anyone else having problem?
#2
Senior Member
My Feedback: (1)
Join Date: Sep 2003
Location: Palm Coast,
FL
Posts: 282
Likes: 0
Received 0 Likes
on
0 Posts
RE: BME 50
Yes, but mine turned out to be a bad ignition switch that would only show up after some heat was generated in flight, maybe 3-5 minutes into the flight. Their customer service is great and I followed all their suggestions and tracked the problem down. Reciently had a high speed problem that they think is the hall effect sensor and it should be here tomorrow. I had used a Great Planes ignition switch that I mounted up front, they don't seem to like heat, replaced the switch and moved it away from heat and no problem since.
#3
Senior Member
Thread Starter
My Feedback: (1)
Join Date: Apr 2002
Location: MadisonLake,
MN
Posts: 205
Likes: 0
Received 0 Likes
on
0 Posts
RE: BME 50
The ingntion was shot, sent it back to C & H again they next day me a new, all works fine.
customer service was good at both BME and C&h .
But they could improve on the sensors, the way they are buildt, and installed is weak.
customer service was good at both BME and C&h .
But they could improve on the sensors, the way they are buildt, and installed is weak.
#5
Senior Member
My Feedback: (14)
Join Date: Dec 2001
Location: Niagara-on-the-Lake ,
ON, CANADA
Posts: 590
Likes: 0
Received 0 Likes
on
0 Posts
RE: BME 50
I had a similar prpoblem on a CH Zenoah G26. CH checked it out and said they found nothing wrong, but they did change the pick-up (sensor) just in case. That must have been the problem as it has worked perfectly ever since.