zdz80 throttle linkage question
#1
Thread Starter
My Feedback: (314)
Join Date: Feb 2002
Location: abilene, TX
Posts: 61
Likes: 0
Received 0 Likes
on
0 Posts
zdz80 throttle linkage question
i recently purchased a used zdz80...it came with the ball links but no connectors.....rcs says they dont have any...i tried making my own linkage - but it came loose from the carb after 5 minutes (did you know a zdz80 will run for 1 hour at 1/4 throttle on 32 ounces of gas???!!) any suggestions?
#3
My Feedback: (9)
RE: zdz80 throttle linkage question
Maybe you're talking about the ball link nylon pieces?
You can pop out the brass balls in the part listed below to fit the ball throttle/choke extension on a ZDZ-80:
Dubro 2160 Swivel Ball Link 4-40
[link]http://www2.towerhobbies.com/cgi-bin/wti0001p?&I=LXD609&P=7[/link]
On all of the pieces I have used, the cup (or groove) for the ball is not perfectly centered. Make sure you orient the part so that the ball is more fully captured.
You can pop out the brass balls in the part listed below to fit the ball throttle/choke extension on a ZDZ-80:
Dubro 2160 Swivel Ball Link 4-40
[link]http://www2.towerhobbies.com/cgi-bin/wti0001p?&I=LXD609&P=7[/link]
On all of the pieces I have used, the cup (or groove) for the ball is not perfectly centered. Make sure you orient the part so that the ball is more fully captured.