Phoenix 10 Settings on Elite CP?
#1
Junior Member
Thread Starter
Join Date: Mar 2004
Location: , CA
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
Phoenix 10 Settings on Elite CP?
I'm setting up my Hummingbird Elite CP with a himax 2015-4100 and CC Phoenix 10 and was wondering if I should run it with fixed throttle or in Governor Mode (high or low?)? I'm also running 3 cell lipo.
Thanks,
Dan
Thanks,
Dan
#2
Senior Member
Join Date: Mar 2004
Location: Lynnwood,
WA
Posts: 377
Likes: 0
Received 0 Likes
on
0 Posts
RE: Phoenix 10 Settings on Elite CP?
I'm running the Phx-10 too. But with a 2-cell lipo on a HB v.II (fixed pitch). I have also used it in my HB CP. Either way, I did not use governor mode. I read in a different post that governor mode doesn't work quite right and opted for the fixed throttle mode on both helis.
Here are all my settings for the HB v.II. The only thing I would change for your circumstance is the cutoff voltage... for your 3-cell lipo.
Here are all my settings for the HB v.II. The only thing I would change for your circumstance is the cutoff voltage... for your 3-cell lipo.
Code:
1 1 D 1 2 U*--> 5.0v 2-cell lipo 1 3 D 6.0v 1 4 D 7.2v cutoff voltage 3-cell lipo 1 5 D 1 6 D 2 1 D 2 2 D 2 3 U*--> Standard Current limit 2 4 D 2 5 D 3 1 D* Soft Delayed Brake 3 2 D 3 3 D 3 4 D 3 5 U --> Brake Disabled 4 1 D* Auto Calibrating Throttle 4 2 U --> fixed throttle (for fixed pitch helis) 4 3 D Governor Mode Low RPM 4 4 D 5 1 D 5 2 U*--> Standard Advance Timing 5 3 D 6 1 D* Hard Cutoff 6 2 U --> Soft Cutoff 7 1 D 7 2 U*--> Soft Start 7 3 D