hb seperate.. ics 300 esc
#1
Member
Thread Starter
Join Date: Jan 2004
Location: butterworth, MALAYSIA
Posts: 58
Likes: 0
Received 0 Likes
on
0 Posts
hb seperate.. ics 300 esc
can i use ics 300 esc at main rotor..????
tx- futaba 8ch
rx- gws 6ch
main rotor- ics 300 esc
tail rotor - ics 50 esc
pico servo
gyro- gy240 heading hold.
tx- futaba 8ch
rx- gws 6ch
main rotor- ics 300 esc
tail rotor - ics 50 esc
pico servo
gyro- gy240 heading hold.
#3
RE: hb seperate.. ics 300 esc
Yes, the ICS300 should be fine for the main. The ICS100 is also good for the main. All of the ESCs you listed will work with 3 cell LiPos. The only thing that will suffer is the tail motor. If you are uaing a stock tail motor, it may not live very long on the higher voltage. This situation can be improved by using a high frequency tail ESC like the Schulze Slim 105he or the TREC
#4
Member
Thread Starter
Join Date: Jan 2004
Location: butterworth, MALAYSIA
Posts: 58
Likes: 0
Received 0 Likes
on
0 Posts
RE: hb seperate.. ics 300 esc
thanks bro... you help a lot... i think u're the nicest guy around here...
one more thing... where should i place my gy240??? the manual said it should be placed 10cm from any motor to avoid inteference
one more thing... where should i place my gy240??? the manual said it should be placed 10cm from any motor to avoid inteference