Spanky18

I know this may have been discussed before but, I am using a Flashpoint Temp Gauge, and during the second tank I read the Temp and it was 323 Farenheit, what do I do?

oatmealman

My Feedback: (1)

richen it out,richen the lsn to,is this your first nitro truck,[8D]

Spanky18

um....how to i richen the low speed needle, the tank is in the way,

and no I have an HPI MT2, Thunder Tiger DT 10, and now a Tmaxx

oatmealman

My Feedback: (1)

take the tank off,or richen the hsn alot 325 degress geez you got it way lean,poor engine[]

dr_killer_uk

Go to factory needle settings then put a cold glow plug in there then tune it and watch it knock a load of your temp and run better, also make sure you got that wind screen cut out. If you are running under 300 i'd say dont' worry, its a race engine its always running on the hot side.

oatmealman

My Feedback: (1)

what he said have you checked for fuel leaks and stuff in the carb

psycooclimber

the gas tank is not in the way. you need to use a small screwdriver, like a .5 jewlers flat head.

foreverNight

yea a small long skinny flat head screwdriver.