Prop holes for 3W 120
#1
Thread Starter
My Feedback: (56)
Join Date: Dec 2001
Location: Steens,
MS
Posts: 447
Likes: 0
Received 0 Likes
on
0 Posts
Prop holes for 3W 120
I got a 28X10 wood prop for my 3W 120 from **** that was already drilled for a six-bolt pattern. When I placed it on the engine the prop holes are just a little bit off (the diameter is less than 1/4 too small) in the current pattern. I can re-orientate the pattern to use undrilled wood but then two holes will be in parallel with the blades. Can this prop be used? I appreaciate your input. Thanks.