Is any one flying the Comp-arf 2.6 Yak with a three blade prop?
#1
Thread Starter
My Feedback: (7)
Join Date: Oct 2003
Location: Post Falls,
ID
Posts: 29
Likes: 0
Received 0 Likes
on
0 Posts
Is any one flying the Comp-arf 2.6 Yak with a three blade prop?
I am setting up my Comp-arf 2.6 Yak and was wondering if any one is flying one with a three blade prop?
I am using a DA-100 with stock mufflers.
25-12 3 blade mejzlik prop.
I was also thinking about 1- 8611 on each aileron, this plane will be set up for only IMAC no 3d. Any one else doing this?
I am thinking that torque should not be an issue and the ailerons seem plenty ridged, the benifit will be the weight savings of two servos, related linkage,and matchboxes.
Any comments welcome.
I am using a DA-100 with stock mufflers.
25-12 3 blade mejzlik prop.
I was also thinking about 1- 8611 on each aileron, this plane will be set up for only IMAC no 3d. Any one else doing this?
I am thinking that torque should not be an issue and the ailerons seem plenty ridged, the benifit will be the weight savings of two servos, related linkage,and matchboxes.
Any comments welcome.