esky gain, proportional and trim
01-08-2005, 07:07 AM
#1
Junior Member
Thread Starter
Join Date: Nov 2004
Location: , ISRAEL
Posts: 21
Likes: 0
Received 0 Likes
on
0 Posts
esky gain, proportional and trim
Hello all, i have the esky 4ch' and 6ch'.
i am now flying my esky 4ch' and cant figure out how to configure the gain, proportional and trim to the optimum
if it can be done?
my problem is that my esky is triimed perfectly while hovering at an X throtel level but when i add
throtel the trimming for the tail is loat and i need to compensate for the tail shifting to the right.
is there any way to configure the three (gain, proportional and trim) in order to achive perfect trimming in most throtel levels?
i am now flying my esky 4ch' and cant figure out how to configure the gain, proportional and trim to the optimum
if it can be done?
my problem is that my esky is triimed perfectly while hovering at an X throtel level but when i add
throtel the trimming for the tail is loat and i need to compensate for the tail shifting to the right.
is there any way to configure the three (gain, proportional and trim) in order to achive perfect trimming in most throtel levels?
01-08-2005, 10:33 PM
#2
Senior Member
Join Date: Nov 2002
Location: Burgaw,
NC
Posts: 643
Likes: 0
Received 0 Likes
on
0 Posts
RE: esky gain, proportional and trim
Well if mine was doing that I would try it like this. If the trim is maxed out in either direction, I would adjust the proportional to bring the trim back closer to center. Then if the hover is good but throttle changes make the heli yaw, I would increase the gain. Remember to cycle power after adjustments.
