toy003

hi guys! i have savage with .21
i m beginner with that truck but not with all rc
first i broke 3 spur ,,, so i bought robinson gear! i dont have any prob after that
secondo! i broke my stock diff,,, i bought my 4 spider gear for 2 diff. but during shipping time for my diff i have install diff lock in rear end,,,, i broke 2 wheel shaft ,,, and for finish all my axe diff in rear too!!!
my drive shaft twist often front and rear its normal?
bearings of rear diff b032 explode ! its normal broke too?
bearings of my clutch bell have small life its normal too?
for my axe diff , its normal broke ?
and , for the rest of truck its good , for this moment!! i bought .25 its not install
if i run my .25 with 14/52 ( i dont race with my savage , just peak in sand pit ) its dangerous for my engine?
thanks a lot guys for your comments

4C8DAN

Hi,

Sounds like its running with its brakes on or something??? All wheel bearings free moving? (sand and bearings may not mix i guess)

Sorry guessing so far... the savage should be tough enough for most uses.

ed260z

Your spur gear broblem is due to bad gear mesh. And I upgraded my entire driveline with in my 1st month, so I'm not sure about your axle problems. I also have a problem wiht my bell bearings, but I can't say I've ever had problems with any other bearing. And I've had my truck for 2 years now.

SavageS27

2 questions for you are you playing in fine sand (dustey and loose) if so not good for the bearing. next after you run it is good to spray all meatel on meatel with WD40 to keep things free moving