Replacement needle valve retainer
#1
Thread Starter
My Feedback: (35)
Join Date: Feb 2002
Location: Vancouver,
WA
Posts: 610
Likes: 0
Received 0 Likes
on
0 Posts
Replacement needle valve retainer
Recently I had the misfortune of breaking the tab of the needle valve retainer clip in my Rossi 45. I was thinking of using a spring hose clip and soldering a piece of piano wire to it as a retainer but I cant find a small enough hose clip . Any ideas? Tks
#4
My Feedback: (9)
RE: Replacement needle valve retainer
I made one from a pocket clip off of a ball point pen. I found one at Wal*Mart that the clip slid on over the end. It might have been a mechanical pencil? Any way I was able to cut the clip shorter and bend a V into it. Works great. You might also try your idea with a Zip tie instead of a hose clamp.
David
David
#6
Senior Member
My Feedback: (18)
Join Date: Jan 2004
Location: Formosa, ARGENTINA
Posts: 2,370
Likes: 0
Received 0 Likes
on
0 Posts
RE: Replacement needle valve retainer
I lost the clip on one of a .40 engine and I just replaced it with a metal wire. If you find one fine enough but pretty stiff, just take a pair of needle nose pliers wrap it around the base a few times and then bend an arc in it so that it touches the needle. It took me about 30 seconds to install and it works perfect and only required a piece of wire I found lying around.