47" edge advice
03-21-2005, 08:00 PM
#1
Member
Thread Starter
My Feedback: (2)
Join Date: Jan 2005
Location: Bayview,
TX
Posts: 46
Likes: 0
Received 0 Likes
on
0 Posts
47" edge advice
Got my kit today and am stoked!
I need help on servo selection, I did a search and read enough to decide on using
my FUT S3151 digitals on the main four but for a micro on the throttle I was going to order a FUT S3101
I just wanted to make sure I was heading the right direction.......
Steve
I need help on servo selection, I did a search and read enough to decide on using
my FUT S3151 digitals on the main four but for a micro on the throttle I was going to order a FUT S3101
I just wanted to make sure I was heading the right direction.......
Steve
03-26-2005, 04:12 PM
#2
Senior Member
My Feedback: (6)
Join Date: Dec 2001
Location: Bellefontaine, OH
Posts: 361
Likes: 0
Received 0 Likes
on
0 Posts
RE: 47" edge advice
Steve
I have had the prototype of your bird for years thanks to Mike! I am running 605's all around and it does fine.
Better servos are always a good idea but standards will work fine for the average+ pilot.
Mike
I have had the prototype of your bird for years thanks to Mike! I am running 605's all around and it does fine.
Better servos are always a good idea but standards will work fine for the average+ pilot.
Mike
03-28-2005, 04:09 PM
#3
My Feedback: (3)
Join Date: May 2002
Location: Beavercreek, OH,
Posts: 4,319
Likes: 0
Received 0 Likes
on
0 Posts
RE: 47" edge advice
Thanks Mike Bell! Good to see you hear buddy and hope the family is well.
Anyway you fly the 40 size profiles just fine with standard servos but speed and power do show marked improvement in performance. A 6v battery pack is the best way to get that extra torque and speed from standard servos.
Anyway you fly the 40 size profiles just fine with standard servos but speed and power do show marked improvement in performance. A 6v battery pack is the best way to get that extra torque and speed from standard servos.
03-28-2005, 08:32 PM
#4
Member
Thread Starter
My Feedback: (2)
Join Date: Jan 2005
Location: Bayview,
TX
Posts: 46
Likes: 0
Received 0 Likes
on
0 Posts
RE: 47" edge advice
Thanks, mike and mike . I ended up with 4 3151 for the mains and an HS-81 fot the throttle to be mounted behind the eng.
I'm assuming I can omit all the throttle servo stuff with the ribs and center section?
Steve
I'm assuming I can omit all the throttle servo stuff with the ribs and center section?
Steve
