Help me
#1
Junior Member
Thread Starter
Join Date: Jul 2005
Location: jupiter,
FL
Posts: 10
Likes: 0
Received 0 Likes
on
0 Posts
Help me
please help. i am semi new to gas powered rc cars and this website. my problem is that my duratrax maximum bx doesnt run right. when i start it and tune down the throttle trim the buggy's wheels keep spinning and when i put it down it takes off(even with the throttle trim is "closed"). What should i do to stop this
thanx.
thanx.
#4
Senior Member
Join Date: May 2005
Location: , UNITED KINGDOM
Posts: 1,170
Likes: 0
Received 0 Likes
on
0 Posts
RE: Help me
It's one of the screws on the carb, not sure which. Download engine manual..
[link=http://www.zenoah.net/products/hobby/download/G230RC_G260RC_307.pdf]here[/link]
Do the adjustment with the wheels off the floor, with minimum throttle at idle..adjust the idle level screw a little, put on the floor (radio gear TX & RX on of course) It could also be the clutch, but unlikely for a new car. Usually a tweak on idle is enough.
[link=http://www.zenoah.net/products/hobby/download/G230RC_G260RC_307.pdf]here[/link]
Do the adjustment with the wheels off the floor, with minimum throttle at idle..adjust the idle level screw a little, put on the floor (radio gear TX & RX on of course) It could also be the clutch, but unlikely for a new car. Usually a tweak on idle is enough.