Saito 72 / Tru-Turn Spinner
#1
Senior Member
Thread Starter
My Feedback: (56)
Join Date: Jan 2004
Location: Fayette,
AL
Posts: 1,183
Likes: 0
Received 0 Likes
on
0 Posts
Saito 72 / Tru-Turn Spinner
I am trying to adapt a Tru-Turn 3 blade alum. spinner to my Saito 72. The snag I have run into is the shaft on the motor does not fill the shaft hole on the spinner backplate. What options do I have for filling the gap so it stays balanced?
#3
Senior Member
Thread Starter
My Feedback: (56)
Join Date: Jan 2004
Location: Fayette,
AL
Posts: 1,183
Likes: 0
Received 0 Likes
on
0 Posts
RE: Saito 72 / Tru-Turn Spinner
Thanks. I wish I had the brains to do a little research before shooting off at the mouth... I went ahead and purchased the whole adapter kit that comes with bushings and the double lock nuts. Since Tru-Turn recommends using this for four stroke motors over the single nut version, I figured I better stick with what the manufacturer says. Thanks again w8ye.[8D]