Profile Gasser?
#1
Member
Thread Starter
Join Date: Oct 2003
Location: Bergen, NORWAY
Posts: 47
Likes: 0
Received 0 Likes
on
0 Posts
Profile Gasser?
Suddebly I have this craving for a big profie funfly[8D]
I was thinking something like the Chip Hyde tunnel vision or the OMP 80" Edge and a suitable gas engine around 30-35cc
Anyone tried this? What would be a good motor choice?
I know of the ROTO 35 but I am unsure of the quallity. The MVVS 26 is too small I think and the 35 Is Heavy, even heavier than the 45.
Then Moki makes a 30cc gasser, any good?
Other possibilities are the radial mounted Zenoah 38 or Fuji 43 but how would you mount them?
All theese questions and no answers, I`m hoping someone will have some thoughts on the subject or even some experience to share
I was thinking something like the Chip Hyde tunnel vision or the OMP 80" Edge and a suitable gas engine around 30-35cc
Anyone tried this? What would be a good motor choice?
I know of the ROTO 35 but I am unsure of the quallity. The MVVS 26 is too small I think and the 35 Is Heavy, even heavier than the 45.
Then Moki makes a 30cc gasser, any good?
Other possibilities are the radial mounted Zenoah 38 or Fuji 43 but how would you mount them?
All theese questions and no answers, I`m hoping someone will have some thoughts on the subject or even some experience to share
#2
Senior Member
My Feedback: (9)
Join Date: Jun 2003
Location: Washington Court House,
OH
Posts: 336
Likes: 0
Received 0 Likes
on
0 Posts
RE: Profile Gasser?
Ya might wanna check out the "Mother of all profiles" page [link=http://www.ohiomodelplanes.com/moap/]here[/link]
A DA 50 would also be a saweet ride on a Hybrid.
A DA 50 would also be a saweet ride on a Hybrid.
#3
My Feedback: (3)
Join Date: May 2002
Location: Beavercreek, OH,
Posts: 4,319
Likes: 0
Received 0 Likes
on
0 Posts
RE: Profile Gasser?
80" Edge has been a popular choice for that size engine. The Moki 2.15 has probably been the most popular gas engine for this plane. I think that is 35cc if my memory serves me right.