Pull the sleeve out
#1
Senior Member
Thread Starter
Join Date: Jul 2005
Location: Pennsauken, NJ
Posts: 568
Likes: 0
Received 0 Likes
on
0 Posts
Pull the sleeve out
Wassup,I just got a new motor and i had a couple problems with it and mistakenly i put the sleeve in wrong so now half of my intake and exhaust ports are closed off because i didnt line it upright when i put it back in and now i cant take out so does anyone know how to remove the sleeve so i can line it up right
#3
Senior Member
Join Date: Aug 2006
Location: MACAU, MACAU
Posts: 611
Likes: 0
Received 0 Likes
on
0 Posts
RE: Pull the sleeve out
Hi,
There should be a little stud on the engine case making sure you have the cylinder facing the right side. Doesn't your engine have that?
You can turn the crankshaft (normal direction it would turn) and the piston will push the cylinder up, once it is up, hold it with a flathead screwdriver, then turn the crankshaft in reverse direction until the binding is gone.
Thx
Joaquim
There should be a little stud on the engine case making sure you have the cylinder facing the right side. Doesn't your engine have that?
You can turn the crankshaft (normal direction it would turn) and the piston will push the cylinder up, once it is up, hold it with a flathead screwdriver, then turn the crankshaft in reverse direction until the binding is gone.
Thx
Joaquim