tartago

I am building a GWS A-10, but I discovered that they didn´t include the CA hinges. After searching through my shop I found a roll of Velcro Treeties about 3/8" wide of the type used in gardening. I first tried beding it several times to be sure of its strenght. as it was tough enough I just cut it in lengths as needed and voilá, perfect CA hinges.
They have rough surface that helps the glue sticking to it. And the dimensions are perfect. Also very cheap.

like this one:

http://altura.speedera.net/ccimg.cat...ts/5775979.jpg

Regards:

Tartago

john_s3

My Feedback: (1)

Cut The Hinges Out Of The Disk In A 3 1/2 " Flopy Disk.Install Just Like CA Hings.Use 5 Minute Epoxy.

tartago

You´re right. I Used them too.

049flyer

My Feedback: (18)

If you have old 5 1/4 inch floppies laying around, the mylar disk inside works well also. Great for foamies and electics. CA sticks to it very well.

tartago

2fast: Floppys work really fine.
I only had trouble with the DOS (LOL)