emaxx transmission 4 crawling?
#1
Junior Member
Thread Starter
Join Date: May 2006
Location: old ocean, TX
Posts: 18
Likes: 0
Received 0 Likes
on
0 Posts
emaxx transmission 4 crawling?
I'm looking to make a crawler. just wonted going to see if a emaxx transmission will work good or just go with a 272?
#5
Senior Member
Join Date: May 2006
Location: State College,
PA
Posts: 621
Likes: 0
Received 0 Likes
on
0 Posts
RE: emaxx transmission 4 crawling?
idk.. i crawl with my e-maxx.. it is mostly stock besides spools and a 65t lathe and single shocks in each corner.. I kept the gear shifter... some times it just needs that little it of extra wheel speed to get over the top.. and when i put it in 2nd gear.. that does it for me. I think it is actually very helpful.
#6
Senior Member
Join Date: Dec 2005
Location: santa rosaamerica
Posts: 1,218
Likes: 0
Received 0 Likes
on
0 Posts
RE: emaxx transmission 4 crawling?
yeah that seems like it might actually be a cool feature, my sw2 is too slow, but if i could shift it, it would help out in those tough areas were wheelspeed is needed!