Escalade body
#1
Banned
Thread Starter
Join Date: Jan 2007
Location: , ON, CANADA
Posts: 270
Likes: 0
Received 0 Likes
on
0 Posts
Escalade body
ive bin lookin for a 2006 cadillac escalade body for my revo 3.3. i kno this is a hpi forum but i was wonderin if anyone cud help me out. on this site http://www.hobbypeople.net/gallery/886740.asp it says under the the body pic that u can get different sizes but im not sure which to get. can anyone with the knowledge of a REVO 3.3 tell me what size i need?
#2
Senior Member
Join Date: Dec 2004
Location: tabernacle,
NJ
Posts: 722
Likes: 0
Received 0 Likes
on
0 Posts
#3
Senior Member
Join Date: Oct 2006
Location: Hamburg, GERMANY
Posts: 1,932
Likes: 0
Received 0 Likes
on
0 Posts
#5
Senior Member
Join Date: Jun 2006
Location: dolbeau-Mistassini,
QC, CANADA
Posts: 392
Likes: 0
Received 0 Likes
on
0 Posts
RE: Escalade body
You can go with the body made for the revo, if you think it'll be too short then just go with the escalade body made for the TNX-MGT.
If you still can'T find it... just go to www.revosucks.com
Have a good day [8D]
If you still can'T find it... just go to www.revosucks.com
Have a good day [8D]
#6
Junior Member
Join Date: Dec 2006
Location: Berlin,
NJ
Posts: 24
Likes: 0
Received 0 Likes
on
0 Posts
RE: Escalade body
I have an Escalade body on my Savage. It is made by HPI for a 200mm or a Savage. I personally like the smaller bodies. I have made a few mods to the body since the picture was taken. I cut a hole in the roof for access to my glow plug, and cut a nole in my windshield and also in my rear window for air to the motor. Also, I run my antenna out the rear window now since I snapped 2 antenna masts from rollovers. Hope this helps.