xgiacox

Parameters work great.... I am new at Heli's and the Blade CP Pro is my first. I added a Heading Lock Gyro. (E-flite G90) I was able to adjust the gain remotely with the Eflite transmitter. How do you do that with the 9C?

Thank you in advance
xgiacox

wingsman

I've just got a blade cp pro over the holidays. I would like to use my Futaba 8U. Would most of the 9c settings work as I'm not familier with it.
Thanks.

wingswest

My Feedback: (6)

I would check in the manual it has an entire section on that.

SSGSPEEDMAN

Anyone have a clue?

tppjr

How did you get CH 5 set to VR-B for the G90? Under Gyro Sens the variable switchs are not available for me. I have a 9C also. It is brand new to me so I must just be missing something but can't seem to figure out how to set up the gyro with it.

Thanks,

Thomas

Enticer

I would like to know also.

Georges Payne

I'm new at this, first heli, first serious computer radio, so I don't know if I did it the right way, but it works. I set up channel 5 by going through Model/Basic/AUX-CH.

Only problem I encountered is to get the same swash plate position than with the stock Tx with the right stick in neutral, I had to set the Subtrims like this,

AIL : +59
ELE : -60
PIT : 0

and it troubles me because it seems a lot to me.

Enticer

Georges, those figures are not really high. When I had my blade i had the subtrim on a couple channels up around 80 and 90. Just adjust the subtrim until you get the servo arms at 90 dedrees.

Kevin.

Georges Payne

Thanks, I played a little with the servo pushrods and I was able to reduce the amount of sub trim required, and everything seems to be working just fine. Those little machines do take a lot of loving care!

Georges