Only one cylinder cycle
#1
Junior Member
Thread Starter
Join Date: Jul 2006
Location: hawley,
PA
Posts: 10
Likes: 0
Received 0 Likes
on
0 Posts
Only one cylinder cycle
When I pull my RC's pull starter, it only compresses and decompresses once. I pull, and it goes putt and then the chord just comes out. I took off the glow starter, and it compresses and decompresses the full cycle of the chord. Any ideas of what is wrong?
#2
Senior Member
Join Date: Jan 2007
Location: campbell,
CA
Posts: 260
Likes: 0
Received 0 Likes
on
0 Posts
RE: Only one cylinder cycle
the owb
one way bearing is shot
u could take off the pull start and take off the owb and soak it in wd40
the blow it off w/ the air hose
that would work 4 a while
thats what i did
one way bearing is shot
u could take off the pull start and take off the owb and soak it in wd40
the blow it off w/ the air hose
that would work 4 a while
thats what i did